MoTeC M8 - Manual (Page 31)

MoTeC Initial Setup 29
Initial Setup
Before attempting to start the engine the setup parameters must be correct.
Use the MoTeC E.M.P. Software to adjust the setup parameters.
Preferably start with a calibration file from a similar engine as this will make
setup faster and easier.
Main Setup
Injectors
IJPU Injector Pulse width scaling
IJCU Current per injector output
IJbc
Injector Battery Voltage Compensation
IJOP Injector Operating Mode (M4 & M48 Only)
Refer to the E.M.P. help screens for details.
Calculation Methods
EFF Efficiency Point Calculation Method. (Advanced Tuning Only)
LOAd Load Point Calculation Method.
Refer to the E.M.P. help screens for details.
Load Sites Selection
Ld S Selects the range of load points to suit the manifold pressure range.
Refer to the E.M.P. help screens for details.
Number of Cylinders
CYLS 4 Stroke engines : use positive numbers eg. 8 for 8 cyl.
2 Stroke engines : use negative numbers eg. -2 for 2 cyl.
Rotary engines : use -2 for 2 rotor and -3 for 3 rotor.
Trigger Types
rESn Ref Sensor Type (M4 & M48 only)