MoTeC BR2 BTX - Manual (Page 25)

MoTeC Configuration 23
For CAN Connection
The beacons specified in the list are transmitted under a different Mode
and ID. The Mode will be 100 and the ID will be based on the order in
the list. Note that the Mode is 100, not 1. The first beacon in the list is
transmitted with the beacon ID equal to zero, the second with the ID
equal to one, etc.
Any beacons that are not in the list will be sent without modification, but
will normally be rejected by the ADL.
The ADL must be configured to receive on Mode 100 (not Mode 1). The
Lap Beacon ID must be set in the ADL to match the transformed ID of
the Lap Beacon. For example if the Lap Beacon is the first ID in the list
then an ID of 0 must be entered, if second in the list then 1 must be
entered.
For Switched Output Connection
The beacons specified in the list are transmitted under a different ID.
The ID will be based on the order in the list. The first beacon in the list
is transmitted with the ID equal to zero, the second with the ID equal to
one, etc. Note that the Mode is not transmitted when using the
Switched Output.
The BR2 will pulse the output for every beacon listed in the table, all
other beacons will be ignored.
The ADL must be configured to receive on Mode 100 (not Mode 1). The
Lap Beacon ID must be set in the ADL to match the transformed ID of