beautypg.com

Special split beacons (for adl) – MoTeC BR2 BTX User Manual

Page 24

background image

22 Configuration

Split Beacons

The ADL automatically handles split beacons if the Mode is the same
for all beacons including the Lap Beacon.

Note that the Beacon Type must be set to ‘BRX with Splits’ and the ID
of the Lap Beacon must be entered.

Split Beacons that have a different Mode from the Lap Beacon can be
used by using the advanced configuration feature of the BR2. Refer to
Special Split Beacons (for ADL) latter in this section.

Note: The Split Lap Times channel should be turned on if split times
are to be displayed on the ADL.

For M8 or M800 ECU

A digital input must be configured for Beacon operation.

The polarity must be set to ‘Active when input Low’.

For MDD

The MDD does not require configuration.

Special Split Beacons (for ADL)

Split Beacons that have a different Mode from the Lap Beacon can be used
by configuring the advanced configuration feature of the BR2.

To change the advanced configuration click on the Advanced Configuration
Settings button.

Each beacon that is to be used must be entered into the list.

To add a beacon to the list, select the Mode from the drop down list, enter the
ID, and then click the Add button.

The Advanced Settings screen is shown below with two beacons already
added to the list.