MoTeC BR2 BTX - Manual (Page 2)

2. Check the Receiver....................................................................................... 26
3. Check the Connected Device (for ADL) ........................................................ 27
4. Check the Operating Range.......................................................................... 28
Appendices....................................................................... 29
Appendix A – Range Specification.................................................................... 29
Appendix B – BTX Specifications...................................................................... 31
Appendix C – BR2 Specifications ..................................................................... 32
Appendix D – BR2 CAN Messages................................................................... 33
Appendix E – BR2 LED Error Codes ................................................................ 37
Appendix F – BR2 Configuration Loom............................................................. 38
Appendix G - Transmitter Wiring.......................................................................39
Appendix H – BR2 Wiring (Switched Output)................................................... 40
Appendix J – BR2 Wiring (CAN) ...................................................................... 41
Appendix K – General CAN Bus Wiring ........................................................... 42
Appendix L – BR2 Mounting Dimensions......................................................... 43
 Copyright - MoTeC Pty Ltd - 2002
The information in this document is subject to change without notice.
While every effort is taken to ensure correctness, no responsibility will be taken for the consequences of any
inaccuracies or omissions in this manual.
6 June, 2003