beautypg.com

Br2 configuration – MoTeC BR2 BTX User Manual

Page 20

background image

18 Configuration

BR2 Configuration Example

In the example below the BR2 is configured to use the Switched Output
connection method and the BR2 will respond to a beacon transmitter with a
Mode setting of 5 and an ID of 55.

BR2 Configuration

The method for configuring the BR2 is dependent on the connection method
and the device that it is connected to as follows:

For ADL using CAN Connection

The BR2 must be configured to use the CAN connection.

The beacon Mode and ID do not need to be set in the BR2, instead they are
set in the ADL.

Note: Normally the configuration does not need to be changed since CAN
operation is the factory default.

Split Beacons

The BR2 does not require further configuration if the split beacons all
use the same Mode as the Lap Beacon.

Split Beacons that have a different Mode from the Lap Beacon can be
used by enabling the advanced configuration feature of the BR2. Refer
to Special Split Beacons (for ADL) latter in this section.