MoTeC BR2 BTX User Manual
Page 21

MoTeC
Configuration
19
For ADL using Switched Output Connection
The BR2 must be configured for Switched Output connection and the Mode
and ID of the Beacon Transmitter must be entered.
Note: it is normally best to use the CAN connection method when connecting
to the ADL.
Split Beacons
If the split beacons all use the same Mode as the Lap Beacon then the
BR2 should be configured so that the Mode is set to match the Mode
used by the transmitters and ‘Any ID’ should be selected.
The BR2 will send a signal to the ADL for every transmitter with the
specified Mode.
Split Beacons that have a different Mode from the Lap Beacon can be
used by enabling the advanced configuration feature of the BR2. Refer
to Special Split Beacons (for ADL) latter in this section.
For M8 or M800 ECU
The BR2 may be used with an M8 & M800 ECU using the switched output
connection method.
The BR2 must be configured for Switched Output and the Mode and ID of the
Beacon Transmitter must be entered.
For MDD
The BR2 must be configured to use the CAN connection.
The Advanced Configuration settings must also be enabled and the Mode and
ID must be entered as the first (and normally the only) beacon in the
Advanced Configuration Settings list.
To add the Mode and ID to the list the Mode and ID must first be selected
then the Add button must be clicked which will copy the settings to the list.
The Advanced Settings screen is shown below with a Mode and ID already
added to the list.