B&K Precision 1785B - Manual - Manual (Page 8)

8
Chapter 1 Quick Start
One of the first things you will want to do with your power supply is to become acquainted with the front
panel. The exercises in this chapter prepare the power supply for use and help you get familiar with
some of its front-panel operations.
This chapter is intended for both the experienced and the inexperienced user because it calls attention
to certain checks that should be made prior to operation.
1.1 Preliminary Checkout
The following steps help you verify that the power supply is ready for use.
1．Check the list of supplied items.
Verify that you have received the following items with your power supply. If anything is missing, contact
your nearest Sales Office.
□ One power cord for your location
□ This User’s Manual.
□ Communication cable
2．Connect the power cord and turn on the power supply.
When you turn on the power supply, the front-panel display will light up briefly while the power supply
performs its power-on self-test. All the VFD annunciators will light up at once. To review the display with
all annunciators, you can check if there is any stroke loss on any annunciator. If there isn’t any response
when you power on the power supply, please see Section 1.5 on page 10 for some service information.
If the EEPROM was damaged or the latest operation data in EEPROM was lost, the VFD will display as
follows:
If the calibration data in EEPROM was lost, the VFD will display as follows:
1.2 Output Checkout
The following procedures check to ensure that the power supply develops its rated outputs and properly
responds to operation from the front panel.
ERR EEPROM
ERROR CAL
Warning : Your power supply is equipped with a 3-wire grounding type power cord;
the third conductor being the ground. The power supply is grounded only when the
power-line cord is plugged into an appropriate receptacle. Do not operate your power
supply without adequate cabinet ground connection.