B&K Precision 1785B - Manual - Manual (Page 33)

33
5.3.2 Status bar
Status bar will give you the communication information. When the communication is successful, the
status bar will display as follows:
1. Model number: it will display the real part number of the field power supply which detected by the
computer. (6811/6812/6821/6822/6823……..).
2. Communication status (Communication successful/Communication waiting), if Communication
waiting appears here for more than 10 seconds, you need to check if there is any connection failure
between computer and power supply. After confirming the effective connection, then re-configure the
baud rate, address, comport etc, to make sure the same baud rate and address between power
supply and computer.
5.3.3 Setting Voltage and current
1. Setting voltage/current by rotary knob
Note: Before you set the current and voltage value from the computer, please change
the operation mode to PC Control mode by pressing button.
Communication status Model number
Use mouse to click on the rotary knob and move mouse
to change the value. You also can use mouse wheel, or
Page Up/Down keys and arrow
keys (↑, ↓, ←, →) from
the keyboard to change the voltage value more slightly.
The setup value will be displayed on the second line
indicator.
Use mouse to click on the rotary knob and move mouse
to change the value. Also you can use mouse wheel,
Page Up/Down keys and arrow
keys (↑, ↓, ←, →) from
the keyboard to change the current value more slightly.
The setup value will be displayed on the second line
indicator.