B&K Precision 1785B - Manual - Manual (Page 32)

32
Configure the software operation environments.
Voltage chart, it can show you a chart of the voltage.
Current chart: it can show you a chart of the current.
To set the remote mode of power supply.
To set the output state ON/OFF
To enable the local numeric key ⑦，it means that if you select “Enable” on this button, when the
power supply is under remote control mode, you can press numeric key ⑦ to change the control
mode to front panel control mode.
Annunciators display.
Status bar, it can show you the power supply model, communication status and operation status.
To set current value, use the rotary knob to set the current value, the setup value and
measurement value will be displayed.
To make a program of voltage and current values for the power supply, or to set the output value
quickly.
Using the rotary knob to set the voltage value, the setup value and present value will be displayed
in the 2 indicators.
5.3.1Configure the system
The first step for communication is to configure the system, click Configure button , the
windows will display as follows:
Note：When you set the communication port, please make sure that the baud rate
and address of the computer are the same as the power supply.
2
10
3
9
8
7
5
4
6
1
11
1) Comm: to set the communication port, baud rate and
address.
2) Max voltage: to set a maximum voltage value in the
voltage range. For example, the voltage range of
IT6822 is 0~32V, then you can set a maximum voltage
at 24V.
3) Voltage/Current step: to set the step size of Arrow key,
page up/down key, and Mouse-wheel. When you set
the value by clicking the knob, you can use the arrow
keys (↑, ↓, ←, →), page up/down keys or mouse wheel
to adjust the value more slightly.
4) Reload last parameter: if you select it, then it will reload
the parameter settings of last time you close this
software.