Atec Rohde-Schwarz-ESCI Series - Manual (Page 9)

Version 03.00, June 2009
Rohde & Schwarz R&S ® ESCI/ESCI7 EMI Test Receiver 9
Power supply for antennas, etc.
Supply voltages
±10 V DC and ground,
max. 100 mA, nominal
USB interface 2 ports, type A plug, version 2.0
AF output
Connector
3.5 mm jack
Impedance 10 Ω
Open-circuit voltage adjustable up to 1.5 V
Inputs and outputs (rear panel)
IF 20.4 MHz
Connector
BNC female
Impedance 50 Ω
mixer level > –60 dBm
RBW ≤ 100 kHz or FFT –10 dBm at reference level
Level
RBW > 100 kHz 0 dBm at reference level
Reference frequency output
Connector
BNC female
Impedance 50 Ω
Output frequency 10 MHz
Level 0 dBm, nominal
Reference frequency input
Connector
BNC female
Input frequency 10 MHz
Required level 0 dBm from 50 Ω
Power supply for noise source
Connector
BNC female
Output voltage switchable 28 V, nominal
External trigger/gate input
Connector
BNC female
Impedance > 10 kΩ
Trigger voltage 1.4 V (TTL)
IEC/IEEE bus remote control interface in line with IEC 625-2
(IEEE 488.2)
Connector 24-pin Amphenol female
Command set SCPI 1997.0
Interface functions SH1, AH1, T6, SR1, RL1, PP1, DC1, DT1,
C0
Serial interface RS-232-C (COM), 9-pin D-Sub
Printer interface parallel (Centronics compatible)
upper connector type A plug, version 1.1 USB interface
lower connector type A plug, version 2.0
External monitor (VGA)
Connector
VGA-compatible, 15-pin D-Sub
User interface 25-pin D-Sub