Gps receiver (option 31), Gated sweep (option 90), Zero span if output (option 89) – Atec Anritsu-MT2720T User Manual
Page 6: I/q waveform capture (option 24), Secure data (option 7)
PN: 11410-00646 Rev. H
MS2720T TDS
Spectrum Analyzer Specifications
Spectrum Master™ MS2720T
Coverage Mapping (Option 431)
Measurements
Indoor MappingRSSI, ACPR
Outdoor MappingRSSI, ACPR
Setup Parameters
Mode
Spectrum Analyzer
Frequency
Center/Start/Stop, Span, Freq Step, Signal Standard, Channel #, Channel Increment
Amplitude
Reference Level (RL), Scale, Attenuation Auto/Level, RL Offset, Pre-Amp On/Off, Detection
Span
Span, Span Up/Down (1-2-5), Full Span, Zero Span, Last Span
BW
RBW, Auto RBW, VBW, Auto VBW, RBW/VBW Ratio, Span/VBW Ratio
Measurement Setup
ACPR, RSSI
Point Distance / Time Setup
Repeat Type Time Distance
Save Points Map
Save KML, JPEG, Tab Delimited
Recall Points Map
Recall Map, Recall KML Points only, Recall KML Points with Map, Recall Default Grid
GPS Receiver (Option 31)
Setup
On/Off, Antenna Voltage 3.3 V/5.0 V, GPS Info
Note: Anritsu 2000-1528-R GPS antenna requires +5 VDC
Anritsu 2000-1652-R GPS antenna requires +3.3 VDC or +5 VDC
GPS Time/Location Indicator
Time, Latitude, Longitude, and Altitude on display
Time, Latitude, Longitude, and Altitude with trace storage
High Frequency Accuracy
< ± 2.5 x 10
–8
with GPS On, 3 minutes after satellite lock in selected mode (GPS Antenna connected)
< ± 5.0 x 10
–8
for 3 days after GPS lock, 0 °C to 50 °C ambient temperature (GPS Antenna disconnected)
Connector
SMA, female
Gated Sweep (Option 90)
Mode
Spectrum Analyzer, Sweep
Trigger
External TTL, IF Level
IF Trigger Level
Full display range of instrument
Setup
Gated Sweep (On/Off)
Gate Polarity (Rising, Falling)
Gate Delay (0 ms to 65 ms typical)
Gate Length (1 µs to 65 ms typical)
Zero Span Time
Zero Span IF Output (Option 89)
Mode
Spectrum Analyzer/Span/Zero Span
Center Frequency
140 MHz
Output Level
–25 dBm typical
Reference Level
–57 dBm to +30 dBm (Preamp Off)
–87 dBm to –40 dBm (Preamp On)
IF Bandwidths
Up to 30 MHz (3 dB bandwidth)
RF Attenuation
Auto
Connector
BNC female
I/Q Waveform Capture (Option 24)
Mode
Spectrum Analyzer
Capture Mode
Single or Continuous
Trigger
Free Run, External (Rising/Falling), Delay
Maximum Capture Length
800 ms
Maximum Sample Rate
40 MHz
Maximum Signal Bandwidth
32 MHz
Secure Data (Option 7)
Set at Factory
Save measurement files on external USB flash drive only
Internal memory is permanently disabled