Atec Agilent-E5052A - Manual (Page 11)

11
Table 1-31. Storage
Internal hard disk drive: Store and recall instrument states and trace data on 10 GB, minimum, internal hard drive. Trace data can be saved
in CSV (comma separated value) format. All files are MS-DOS ® -compatible. Instrument states include all control
settings and memory trace data.
File sharing: Internal hard disk drive (F:) can be accessed from an external Windows ® PC through LAN or USB (USBTMC)
Disk drive: Instrument states and trace data can be stored on an internal 3.5 inch 1.4 MB floppy disk in MS-DOS-compatible
format
Screen hard copy: Printouts of instrument data are directly produced on a printer. The analyzer provides USB and parallel interfaces
Table 1-32. System capabilities
Familiar graphical
The analyzer employs a graphical user interface based on Windows ® operating system. There are three ways to
user interface: operate the instrument manually: you can use a hard key interface, a touch screen interface, or a mouse interface.
Limit line
Limit test Define the test limit that appears on the display for pass/fain testing. Defined limits may be any combination
of horizontal/sloping lines and discrete data points.
Table1-33. Function differences between standard and E5052A-011
Descriptions
Standard E5052A-011
Phase noise measurement
Offset frequency
1 Hz to 40 MHz 10 Hz to 40 MHz
IF gain 0, 10, 20, 30, 40, 50 dB 0, 10, 20 dB
Enhanced phase noise sensitivity Yes (1 to 10,000 correlations) No
Phase noise sensitivity See table 1-2 See table 1-3
Frequency, RF power, DC current measurement
Measurement parameters
Analyzer mode: Tester mode:
Frequency versus DC control voltage dF/dV control Frequency, power, and DC current
(tuning sensitivity) (at DC power port)
Frequency versus DC power voltage (frequency pushing),
dF/dV power
RF power versus DC control voltage or DC power voltage
DC current (at DC power port only) versus
DC control voltage or DC power voltage
Tester mode:
Frequency, power, and DC current (at DC power port)
Table 1-34. Automation
Methods
Internal analyzer execution: Applications can be developed in a built-in VBA® (Visual Basic for Applications) language. Applications can
be executed from within the analyzer via COM (component object model) or using SCPI.
Controlling via GPIB The GPIB interface operates to IEEE 488.2 and SCPI protocols. The analyzer can be controlled by a GPIB
or USB (USBTMC): external controller. The analyzer can control external devices using a USB/GPIB interface.
Controlling via USB The USB interface operates with USBTMC and SCPI protocols. The analyzer can be controlled with an
(USBTMC): external PC using the USB interface with a USB cable.
LAN
Standard conformity: 10 base-T or 100 base-TX (automatically switched), Ethertwist, RJ45 connector
Protocol: TCP/IP
Function: Telnet,
SICL-LAN
Table 1-35. E5001A SSA-J precision clock jitter analysis software
Description
Specification
Measurement parameters Random jitter (RJ), Periodic jitter (PJ) frequency, PJ rms, Jitter trend (TJ vs. time), TJ p-p, PJ p-p, PJ d-d
Jitter spectrum bandwidth 1 Hz to 40 MHz (standard)
10 Hz to 40 MHz (Option E5052A-011)