Atec Aeroflex-IFR-3416 - Manual (Page 6)

SSB AM Noise
SSB AM noise at 20 kHz offset (Typical values) measured at levels
> 0 dBm
Frequency MHz CW/IQ (dBc/Hz)
3 GHz -130
6 GHz -125
RF Leakage
< 0.5 µV PD at the carrier frequency into a single turn 25 mm loop
25 mm or more from the case of the signal generator, for carrier fre-
quencies < 3 GHz
Wideband Noise
Applicable for all carrier levels at offsets > 5 MHz and < 50 MHz
excluding thermal noise (23°C ± 5°C)
RF Mode 375 MHz 3 GHz 6 GHz
(dBc/Hz) (dBc/Hz) (dBc/Hz)
Power < -138 < -142 (-148 typ) < -136
Noise < -138 < -142 (-148 typ) < -136
ACP < -135 < -140 < -134
FM, AM and M can be applied to the carrier using internal or exter-
nal modulation sources. The internal modulation source is capable of
generating two simultaneous signals into any one of the modulation
channels. The internal and external modulation sources can be simul-
taneously enabled in order to produce combined amplitude and fre-
quency (or phase) modulation.
Internal and external IQ modulation can be applied. In this mode, FM,
AM and M are not permitted.
Optional Pulse modulation can be used in combination with FM, AM,
M and IQ from an external pulse source.
FREQUENCY MODULATION
Peak Deviation
Frequency Maximum Peak Deviation
250 kHz to 375 MHz 7.5 MHz
375 MHz to 750 MHz 3.75 MHz
750 MHz to 1.5 GHz 7.5 MHz
1.5 GHz to 3 GHz 15 MHz
3 GHz to 6 GHz 30 MHz
Displayed resolution is 4 digits or 1 Hz.
FM Accuracy
At 1 kHz rate
± 3% of set deviation excluding residual FM
FM Bandwidth
0.5 dB DC to 200 kHz (DC coupled, 100 k )
10 Hz to 200 kHz (AC coupled, 100 k )
3 dB Typically 20 MHz (DC or AC coupled, 50 )
Carrier Frequency Offset
For DC coupled FM ± (1 Hz + 0.1% of set deviation) after performing
a DCFM null operation
Total Harmonic Distortion
At 1 kHz rate
< 0.15% for deviations up to 2% of maximum allowed deviation
< 0.6% for deviations up to 20% of maximum allowed deviation
< 1.5% at maximum deviation
PHASE MODULATION
Phase Deviation
0 to 10 radians
Displayed resolution is 4 digits or 0.01 radians.
Accuracy
At 1 kHz rate
± 4% of set deviation excluding residual phase modulation
Bandwidth
0.5 dB 100 Hz to 10 kHz (AC coupled, 100 k )
Total Harmonic Distortion
At 1 kHz rate
< 0.5% at 10 radians deviation
Typically < 0.1% at 1 radian deviation
AMPLITUDE MODULATION
Specifications apply for carrier frequencies from 2 MHz up to 2 GHz,
Maximum specified output power is reduced by 2 dB,
Modulation Depth
0 to 99.9%, Displayed resolution is 3 digits or 0.1%