Atec Agilent-ECP-E26A - Manual (Page 30)

1 Introduction
14 Agilent E4412A and E4413A Power Sensors Operating and Service Guide
Power Meter Calibrations
Follow the calibration procedures given in your power meter manual. The
E4413A power sensor is fitted with 3.5 mm (m) connectors as standard. To
convert the 3.5 mm (m) connector for calibration, an adapter (3.5 mm (f) to
Type- N (m)) is included with the power sensor. See
Figure 3 .
Figure 3 E4413A power sensor with adapter
Operating Instructions
The E4412A and E4413A power sensors are compatible ONLY with the newer
E44XX- Series power meters. They are NOT compatible with the earlier
430- Series, E1416A, or 70100A power meters. To operate the power sensor,
refer to the operating instructions in the Agilent E44XX- Series Power Meter
User’s Guide.
N O T E
The 3.5 mm to Type-N adapter is intended for the use of 1 mW, 50 MHz power reference of
the power meter only. Its function as a calibration reference may be compromised if it is
used for other purpose.