Atec Agilent-ECP-E26A - Manual (Page 20)

1 Introduction
4 Agilent E4412A and E4413A Power Sensors Operating and Service Guide
These power sensors measure CW power, displayed on a compatible power
meter in logarithmic (dBm or dB) or linear (Watts or %) measurement units.
The E4413A is shipped with a 3.5- mm to Type- N adapter, part number
08485- 60005.
Specifications
The specifications listed in Table 1 are the performance standards or limits
against which the power sensor may be tested. These specifications are valid
ONLY after proper calibration of the power meter. Refer to the Calibration
Procedure Using Agilent E- Series Power Sensors in the E4418A or the
Agilent E4419A Power Meter User’s Guide.
N O T E
The E4412A and E4413A power sensors are compatible ONLY with the newer E44XX-Series
power meters. They are NOT compatible with the earlier 430-Series, E1416A, or 70100A
power meters.
N O T E
The E4412A and E4413A power sensors are extremely static- sensitive. Do not open the
power sensor unless you and the power sensor are at a static-free workstation.