Atec Agilent-ECP-E26A - Manual (Page 11)

xi
General Safety Information
The following general safety precautions must be observed during all
phases of operation, service, and repair of this instrument. Failure to
comply with these precautions or with specific warnings elsewhere in this
manual violates safety standards of design, manufacture, and intended
use of the instrument. Agilent Technologies assumes no liability for the
customer’s failure to comply with these requirements.
WA RN I N G
BEFORE CONNECTING THE POWER SENSOR TO OTHER INSTRUMENTS
ensure that all instruments are connected to the protective (earth)
ground. Any interruption of the protective earth grounding will cause a
potential shock hazard that could result in personal injury.
C A U T I O N
• Use the device with the cables provided
• Repair or service that is not covered in this manual should only be
performed by qualified personnels.
C A U T I O N
• This product is designed for use in Installation category II and Pollution
Degree 2.
• This instrument has been designed and tested in accordance with IEC
Publication 248, Safety Requirements for Electronic Measuring
Apparatus, and has been supplied in a safe condition. The instruction
documentation contains information and warnings which must be
followed by the user to ensure safe operation and to maintain the
instrument in a safe condition.
• Notice for germany: Noise Declaration L
rA < 70 dBm am Arbeitsplatz
(operator position) mormaler Betrieb (normal position) nach DIN 45635
T.19 (per ISO 7779).