Atec Agilent-DSO8104A - Manual (Page 20)

20
Infiniium Performance Characteristics
(continued)
Trigger: scope channels DSO8064A, MSO8064A, DSO8104A, MSO8104A
Sensitivity
Internal 6 DC to 600 MHz: 0.6 div
600 MHz to 1 GHz: 1.5 div (50
Ω)
Auxiliary DC to 600 MHz: 300 mVp-p
Level range
Internal ± 8 div from center screen (1 M Ω)
± 8 div from center screen (50
Ω)
Auxiliary ± 5 V
Sweep modes Auto, triggered, single
Trigger coupling DC, AC, low frequency reject (50 kHz high pass filter), high frequency reject
(50 kHz low pass filter)
Trigger conditioning Noise reject adds hysteresis to trigger circuitry decreasing sensitivity to noise
Trigger holdoff range 50 ns to 10 s
Trigger jitter 8 ps ± 0.05 ppm x |delay setting| rms
Trigger rate
Normal real-time acquisition mode > 5,000 max triggers/second
Equivalent-time acquisition mode > 23,000 max triggers/second
Trigger actions Specify an action to occur, and the frequency of the action, when a trigger condition occurs.
Actions include: e-mail on trigger and QuickMeas+ functions
Trigger modes
Edge Triggers on a specified slope and voltage level on any channel, auxiliary trigger or line input.
Glitch Triggers on glitches narrower than the other pulses in your waveform by specifying a width
less than your narrowest pulse and a polarity. Minimum glitch width is 500 ps (scope
channels) or 2.5 ns (digital channels). Glitch range settings: <1.5 ns to <10 s (scope
channels), <5 ns to <10 s (digital channels).
Line Triggers on the line voltage powering the oscilloscope.
Pattern Triggers when a specified logical combination of the channels is entered, exited, is present
or absent for a specified period of time or is within a specified time range. Each channel
can have a value of high (H), low (L) or don’t care (X).
State Pattern trigger clocked by the rising or falling edge, or both, of one channel.
Logic type: AND or NAND.
Delay by time The trigger is qualified by an edge. After a specified time delay between 5 ns to 10 s, a
rising or falling edge on any one selected input will generate the trigger.
Delay by events The trigger is qualified by an edge. After a specified delay between 1 to 16,000,000 rising or
falling edges on any one selected input will generate the trigger.
TV Trigger on one of the three standard television waveforms: 525 lines/60 Hz (NTSC)
625 lines/50 Hz (PAL), or define a custom waveform.
Violation triggers
Pulse width See Trigger Mode Glitch for performance characteristics. Greater than and less than
selections available.
Setup/hold Triggers on setup, hold or setup and hold violations in your circuit. Requires a clock and
data signal on any two input channels as trigger sources. High and low thresholds and
setup and/or hold time must then be specified.
Transition Trigger on pulse rising or falling edges that do not cross two voltage levels in greater than or
less than the amount of time specified.