Atec Agilent-N9923A - Manual (Page 3)

3
FieldFox RF Vector Network Analyzer
Description Specification Supplemental Information
Frequency range
2 MHz to 4 GHz Option 104
2 MHz to 6 GHz Option 106
Frequency reference
Accuracy ±2 ppm
Aging rate ±1 ppm/yr
Temperature stability ±1 ppm over -10 to 55 ºC
Frequency resolution 1 Hz < 3.2 GHz
1.2 Hz > 3.2 GHz
Data points 101, 201, 401, 601, 801, 1001, 1601, 4001, 10,001 (custom number of
points can be set using SCPI)
Measurements S11, S21 magnitude and phase
S22, S12 magnitude and phase (option 122)
Formats Log magnitude, linear magnitude, VSWR,
phase, Smith chart, polar, group delay,
unwrapped phase, real, imaginary
Directivity
Corrected, with full two-port
calibration, N9910X-800 calibration
kit (option 122)
42 dB
Corrected with QuickCal (option 112) 38 dB (typical)
System impedance 50Ω (nominal) 75Ω with appropriate adapter and
calibration kit
System dynamic range 1 (IF bandwidth = 300 Hz, 32 averages)
2 MHz to 6 GHz 90 dB 100 dB (typical)
Receiver dynamic range 2 (IF bandwidth = 300 Hz)
2 MHz to 6 GHz 104 dB (typical)
Receiver compression level at 0.1 dB compression +10 dBm (typical)
Test port output power
High +5 dBm (nominal)
Low -40 dBm (nominal)
Manual Power settable in 1 dB steps
Test port 1 or 2 damage level
2 MHz to 6 GHz +23 dBm
Trace noise (high output power, IF bandwidth = 300 Hz)
Magnitude < 3 GHz, 0.008 dB rms (typical)
> 3 GHz, 0.01 dB rms (typical)
Temperature stability
Stability magnitude 0.01 dB/ºC at 23 ºC ±5 ºC (typical)
IF bandwidths 300 Hz, 1 kHz, 3 kHz, 10 kHz, 30 kHz
1. System dynamic range = source maximum output power - receiver noise floor
2. Receiver dynamic range = receiver maximum input level - receiver noise floor