Associated Equipment 12-1015 Manual - Manual (Page 18)

- 18 -
Model 12-1015 Users’ Manual Version 13.08
Associated Equipment Corp.
5043 Farlin Ave. 800-949-1472(US)
St. Louis, MO 63115 314-385-5178 (Outside US)
7. If the surface charge is too great for the analyzer to handle, it will prompt
you with the instructions as shown: (Fig. 20) below.
8. Wait until the surface charge removal had completed, the analyzer will
advise as follows: (Fig.21) and then press key.
9. If there is no surface charge present, then it will straight away enter into
“Select Battery” menu screen as shown in Fig. 22
Figure 21
Figure 22
Figure 20
Battery surface
charge is present!
Turn the ignition
key to ON position.
Switch ON the
headlights to remove
surface charge.
Battery surface
charge has been
removed.
Turn ignition key to
OFF position.
Switch OFF the
headlights and then
press [Enter].
Select Battery
SLI (Wet Type)
AGM (Flat/Spiral)
[Enter] to proceed