Associated Equipment 12-1015 Manual - Manual (Page 11)

- 11 -
Model 12-1015 Users’ Manual Version 13.08
Associated Equipment Corp.
5043 Farlin Ave. 800-949-1472(US)
St. Louis, MO 63115 314-385-5178 (Outside US)
5.0 – MODEL 12-1015 Setup
5.1 Printer Installation
1. The Analyzer has to be connected to an external power source by clamping
its clips directly to a 12Volt car battery to turn on the printer. The red LED
indicates the printer is on and green LED blinks when printing. (Fig. 3).
2. Open the printer cover (Fig.4a). Place the thermo paper roll into the slot with
the paper edge facing up (Fig. 4b). Make sure the paper is about 20mm out
when the printer cover is closed (Figure 4c).
5.2 Select Display Language
To change the display language of the Analyzer, this can be done while on the
wake up screen (see fig.5 below). First go to Setup Menu by pressing key
until it has been highlighted and then press key to enter.
Figure 3
Figure 4a Figure 4b Figure 4c