Alpha Technologies Te45 - Manual (Page 18)

Alpha Technologies Ltd. 057-106-C0 Rev D
Burnaby, British Columbia. Telephone: 604 436 5900 Fax: 604 436 1233. Page 9 of 38
2.11 Rear access panel
There are three rear access panels. The top panel is a slam latch panel. The lower two panels use internal wing-
studs that must be removed to lift off the panels. The following procedure explains how to remove the rear panels:
Remove rear top panel
CAUTION:
The rear panels are
connected by a
ground strap and
release cable, but can
fall upon release.
Pull on handle to
release top rear panel
Remove each set of wing
nuts, one on each side, to
release the lower panel.
To remove rear
panel, disconnect
lanyard and ground
strap once the panel
is released
Figure 10 – Rear panel latch
Figure 11 – Rear panel released
Figure 12 – Wing nuts retaining lower panels
Figure 13 – Disconnect lanyard and ground strap
When installing the rear panels,
first install the lower panel, and
then install the middle panel.
When installing either panel, first
connect the ground strap, then
move the panel into place, and
finally tighten the wing nuts
securely.
On the upper panel, re-install the
ground strap and re-attach the
lanyard as shown