Franklin Fueling Systems TSP-IGF4P Phase Separation Float Installation - Manual

The TSP-IGF4P floats are installed on the shaft of a Franklin Fueling
Systems TSP-LL2 liquid level probe. The floats are used in tanks that
contain gasoline with or without ethanol blends up to 15%.
The kit includes a product float, which is designed to float on the
product surface. The kit also includes a “water / phase separation” float
designed to sink through product and float above any water or phase
separated ethanol / water that may collect at the bottom of the tank.
The water / interface float is color-coded half red and half white for easy
identification.
Figure 1 shows these floats.
Figure 1: TSP-IGF4P Floats
Four Inch Float Kit
for Gasoline & Ethanol Blends
Model TSP-IGF4P
Installation Instructions
page 1 of 2
Product Float
(Magnet End Up)
Water /Interface Float
(Magnet End Up)