Extron Electronics SW MTP T Series User Guide - Manual (Page 8)

SW MTP T Series Switchers • Installation SW MTP T Series Switchers • Installation
Installation
2-3
(2) 4-40 x 3/16" screws
Use 2 mounting holes on
opposite corners
VersaTools Rack Shelf
1/2 Rack Width False Front
Face Plate
Figure 2-1 — Mounting the SW MTP T on a
VersaTools rack shelf
Use 2 mounting holes on
opposite corners. (2) 4-40 x 3/16"
Screws
1U Universal Rack Shelf
Front false
faceplate
uses 2
screws.
1/2 Rack Width Front False
Faceplate
Figure 2-2 — Mounting the SW MTP T on a 1U
universal rack shelf
Mounting the Switcher
The SW MTP T can be set on a table, mounted on a rack shelf,
mounted to a rack without a shelf, or mounted under a desk,
podium, or tabletop.
Tabletop use
Four self-adhesive rubber feet are included with the switcher.
For tabletop use, attach one foot at each corner of the bottom
side of the unit and place the unit in the desired location.
Rack mounting
For optional rack mounting, do not install the rubber feet.
Mount the switcher on a standard or basic 19" 1U VersaTools
™
rack shelf (Extron part #60-190-20 or #60-604-20) or a standard
or basic 1U Universal rack shelf (Extron part #60-190-01 or
#60-604-01). On the Universal rack shelves, the switcher
mounts in one of two locations to the rear of the rack or in one
of two locations to the front of the rack.
1 . Remove rubber feet if they were previously installed on
the bottom of the switcher.
2 . Mount the switcher on the rack shelf, using two
4-40 x 3/16" screws in opposite (diagonal) corners to
secure it to the shelf (figure 2-1 and figure 2-2).
3. Install blank panel(s) or other unit(s) on the rack shelf.
4. Attach the rack shelf to the rack using the supplied bolts.
Only products in the VersaTools line can be mounted on
a VersaTools shelf. Most 1U rack-mountable Extron
products can be mounted on the standard shelf.
2-2