Extron Electronics SW MTP T Series User Guide - Manual (Page 3)

SW MTP T Series Switchers • Quick Start Guide
Install and operate the SW MTP T Series switchers as follows:
Step 1
Turn all of the equipment off and disconnect it from the power
source.
Step 2
Mount the switcher in a rack or furniture, or place on a desktop.
Step 3
Connect up to six video input cables ,
depending on the switcher model.
Connect up to six audio input cables ,
depending on the switcher model.
Step 4
Connect the Twisted Pair (TP) video and audio output cable .
Step 5
Connect the other end of the TP cable to an MTP R 15HD A or
MTP RL 15HD A receiver.
Quick Start Guide — SW MTP T Series
QS-1
1
Video Input
Connector
Audio Input
Connector
5
Pin
1 Red+/V. sync+
2 Red–/V. sync–
3 Mono audio+
Green–
6 Mono audio–
7 Blue+/H. sync+
8 Blue–/H. sync–
4
Wire color
White-green
NOTE If you are using Enhanced Skew-Free™
A/V cable, use the TIA/EIA T 568A
standard only.
Green
White-orange
White-blue
Orange
White-brown
Brown
Wire color
568 A 568 B
Signal
White-orange
Orange
White-green
White-blue
Green
White-brown
Brown
Clip Down Side
1
1&2
3&6 4&5
7&8
2 3 4 5 6 7 8
1 Pins 2 3 4 5 6 7 8 RJ-45
connector
Twisted
Pairs
Green+ Blue Blue