Extron Electronics SEQ 100 15HD User Guide - Manual (Page 9)

VersaTools ® SEQ 100 Skew Equalizer
VersaTools ® SEQ 00 Skew Equalizer, cont’d
0 VersaTools ® SEQ 100 Skew Equalizer
PMK 00 mounting
Mount the SEQ to a PMK 300 bracket (figure 8) as follows:
Extron
PMK 300
Multi-product Projector Mount Kit
U-Bolt
Front Mounting
Plate
Side Mounting
Plate
Extron
SEQ 100 15HD
Power Supply
Bracket
Brace
Figure 8 — PMK 300 projector mounting an SEQ
1 . Remove feet from the bottom of the SEQ if installed.
2 . Mount the SEQ to one of the bracket’s three mounting
plates using two of the supplied 4-40 x 3/16" screws in
opposite (diagonal) corners to secure the device to the
bracket. It can be vertically mounted facing either up or
down (figure 8).
N On the side mounting plates, the device is typically
mounted on the outside of the bracket.
On the front mounting plate, the device is typically
mounted on the inside of the bracket.
3 . If the power supply is connected to the SEQ , use the two
included tie wraps to strap the power supply to one of the
brackets.
N The PMK 300 has a hole in the bottom plate that allows
the projector pole to be inserted through the center of the
plate (figure 9), rather than outside of the plate (figure 8).
To install the PMK 300 in this configuration, slide the
bracket up from the bottom of the pole before the projector
is installed on the pole.
U-Bolt Extron
PMK 300
Multi-product Projector
Mount Kit
Bracket
Brace
Figure 9 — Projector pole on the inside
4 . Place the contoured bracket brace against the pole and
opposite the back plate. The pole should fit snugly into the
depression in the center of the bracket brace.
5 . Place the U-bolt around the ceiling pole and insert the
two legs of the U-bolt through the round holes on the
contoured bracket brace and then through the slotted holes
on the bracket’s mounting plate.
N The supplied U-bolt fits a typical (1.5" to 2.0" diameter)
ceiling pole.
6 . Secure the bracket to the U-bolt with the included hex
nuts, washers, and lock washers. Tighten the hex nuts just
enough that they can be loosened by hand.