Extron Electronics SEQ 100 15HD User Guide - Manual (Page 8)

VersaTools ® SEQ 100 Skew Equalizer
VersaTools ® SEQ 00 Skew Equalizer, cont’d
VersaTools ® SEQ 100 Skew Equalizer
Furniture mounting
Furniture mount the SEQ using the optional MBU 123
VersaTools under desk mounting kit, part #70-212-01 (figure 6),
as follows:
Figure 6 — Desk mounting the SEQ
1 . Remove feet from the bottom of the SEQ if installed.
2 . Remove two screws from one side of the unit. Retain the
screws for possible later reassembly without the bracket.
3 . Attach one bracket to the side of the unit using the longer
screws included in the kit.
4 . Repeat steps 2 and 3 on the other side of the unit.
5 . Hold the SEQ with the attached brackets against the
underside of the table or other furniture. Mark the location
of the screw holes of the bracket on the mounting surface.
6 . Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)
deep in the mounting surface at the marked screw
locations.
7 . Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until just less than
1/4" of the screw protrudes.
8 . Align the mounting screws with the slots in the brackets
and place the SEQ against the surface, with the screws
through the bracket slots.
9 . Slide the SEQ slightly forward or back, then tighten all
four screws to secure the SEQ in place.
Projector mounting
The SEQ can be mounted on a projector bracket using either of
the following optional Extron projector mounting kits:
• PMK 100 projector mounting kit (part #70-217-01)
• PMK 300 projector mounting kit (part #70-374-01)
• PMK 350 low profile projector mounting kit
(part #70-563-02 [black] or part #70-563-03 [white])
PMK 00 mounting
Projector mount the SEQ using an optional PMK 100 bracket
(figure 7) as follows:
Ceiling
Digital Projector
Projector
Mounting
Bracket
Mounting
Bolt
Projector Mounting
Figure 7 — Desk and projector mounting the SEQ
1 . Remove feet from the bottom of the SEQ if installed.
2 . Remove two screws from one side of the unit. Retain the
screws for possible later reassembly without the bracket.
3 . Attach one bracket to the side of the unit using the longer
screws included in the kit.
4 . Secure the SEQ to a projector mount or other surface by
inserting the mounting bolt through the bracket’s slotted
hole.