Extron Electronics SEQ 100 15HD User Guide - Manual (Page 7)

VersaTools ® SEQ 100 Skew Equalizer
VersaTools ® SEQ 00 Skew Equalizer, cont’d
VersaTools ® SEQ 100 Skew Equalizer
Back of the rack installation
The SEQ 100 can be mounted to the rear of a rack using the
Extron MBB 100 VersaTools back of the rack mounting kit
(part #70-367-01) (figure 4). The kit allows the product to be
vertically mounted to the front or rear rack supports and facing
either towards the front or the rear of the rack.
Figure 4 — Attaching the back of the rack kit
1 . Remove feet from the bottom of the SEQ if installed.
2 . Remove two screws from one side of the unit. Retain the
screws for possible later reassembly without the bracket.
3 . Attach one bracket to the side of the unit by using the
longer screws included in the kit.
4 . Repeat steps 2 and 3 on the other side of the unit.
5 . Mount the unit to the rack using the two included rack
screws (figure 5). The SEQ can be vertically mounted
facing in either direction.
N Only VersaTools products and most IP Link products
can be mounted using the back of the rack mounting kit.
MA V SERIE
S
AV M ATR IX S WIT CHE R
I/O
AUD
AUD IO S ETU P
PRE SET
VID
IR
+dB -dB
ENT ER
2
7
6
5
2
4
1
INPU TS
OUT PUT S
8
3
1
8
6
5
4
3
7
Figure 5 — Typical back of the rack installations