Configuring the ipl 250 with global configurator – Extron Electronics IPL 250 Setup Guide User Manual

Page 17

2-7

Refer also to the IPL 250 Reference Manual at www.extron.com.

IPL 250 • Setup

You can reconnect using either Telnet or a Web browser to verify that the

update was successful.

After verifying that the IP address change was successful, enter and issue the

“arp –d” command at the DOS prompt. For example:

arp –d 10.13.197.7 removes 10.13.197.7 from the ARP table

arp –d* removes all static IP addresses from the ARP table.

Configuring the IPL 250 with Global Configurator

After you install the Global Configurator (GC)

software on the PC and have download

device drivers, do the following:
• create a GC project file
• configure the IPL 250 and other IPL devices
• launch the GlobalViewer

interface

• test the configuration and the system
The Global Configurator Help file includes

an introduction to the software

("Introduction") and a section ("Getting

Started") on how to start a Global

Configurator project. It also features step-by-

step instructions on the basic tasks involved

in configuring an IPL 250.
An example of the topics available in the

GC help file is shown at right. Sections

recommended for your reading are indicated

by boxes in the figure at right.

If you have questions during installation

and setup, you can call the