Wiring, Power, Control – Extron Electronics IPL 250 Setup Guide User Manual
Page 14: Wiring -4, Power -4 control -4, Setup, cont’d, Ipl 250 • setup, Ethernet/lan ( b ), Serial/rs-232 ( c , d ), Contact closure input ( g )
Setup, cont’d
2-4
Refer also to the IPL 250 Reference Manual at www.extron.com.
IPL 250 • Setup
Power
Connect the
Extron 12 VDC,
1.0 A (max.)
power supply
to a as shown
here:
N
You must
use the supplied
Extron external 12 V,
1.0 A power supply.
Control
Ethernet/LAN (b)
RJ-45
Connector
Insert Twisted
Pair Wires
Pins:
12345678
Straight-through Cable
(for connection to a switch, hub, or router)
End 1
End 2
Pin
Wire Color
Pin Wire Color
1
white-orange
1
white-orange
2
orange
2
orange
3
white-green
3
white-green
4
blue
4
blue
5
white-blue
5
white-blue
6
green
6
green
7
white-brown
7
white-brown
8
brown
8
brown
Crossover Cable
(for direct connection to a PC)
End 1
End 2
Pin
Wire Color
Pin Wire Color
1
white-orange
1
white-green
2
orange
2
green
3
white-green
3
white-orange
4
blue
4
blue
5
white-blue
5
white-blue
6
green
6
orange
7
white-brown
7
white-brown
8
brown
8
brown
Tie
Wrap
Ridges
Smooth
Wiring
C
Installation and service must be performed by authorized personnel only.
Attach cables using the following wiring diagrams as a guide. Full details are
available in the IPL 250 Reference Manual.
Serial/RS-232 (c, d)
Wiring for COM 3 is the same as for
COM 2.
COM1
TX RX
RTS CTS
COM 2
TX RX
Tr
ansmit (Tx)
Receiv
e (Rx)
Ground (GND)
Tr
ansmit (Tx)
Receiv
e (Rx)
Ground (GND)
Request to send (R
TS)
Clear to send (CTS)
Strip wires
3/16”
(5 mm)
max.
Contact closure input (g)
INPUT
1 2 3 4
IPL 250
Rear Panel
Switch,
Sensor
2
1
3
4
Heat Shrink
Over Shield