Extron Electronics DVC 501 SD User Guide - Manual (Page 14)

DVC 501 SD • Installation 8
3. Click Next . On the next screen, make sure that the Install the software
automatically (Recommended) radio button is selected, then click Next (you do not
need to insert a disc).
Figure 8. Selecting the Radio Button to Install the USB Driver Automatically
Your computer locates the driver needed for it to communicate with the DVC 501 SD via
the USB port.
4. When the Completed screen appears, click Finish to close the wizard.
NOTE: This wizard appears only the first time you connect the DVC to each USB
port. You do not see the wizard again unless you connect the DVC to a
different USB port on your computer.
5. Configure the DVC as desired, using SIS commands (see the “ Using SIS Commands ”
section for more information).