Extron Electronics DVCM 50 Quick Start Guide - Manual (Page 4)

DVCM 50 Quick Start Guide, cont’d
DVCM 50 • Quick Start Guide 2
PRELIMINAR
Y
PRELIMINAR
Y
PRELIMINAR
Y
2 Enable Macro LED — The LED located immediately above the four green IR
LEDs is labeled E, for Enable Macro. This LED lights orange when you place
a button in macro mode. (See Setting up button macros, later in this guide.)
3 IR learning indicator LEDs — Each front panel button has four memory
blocks, which can be programmed with up to four IR commands. The IR
learning indicator LEDs indicate the following:
• Which of the four memory blocks contains a command
• Which of the four memory blocks is ready to be programmed or
confi gured.
• The IR learning status of the control module
4 Button Indicator LEDs — These LEDs light in various patterns to indicate
which button on the front panel has been pressed when the DVCM is in
learning mode (confi guration switch #1 is in the On (up) position).
5 Control and power connector — This fi ve-pole, 3.5 mm captive screw
connector is used for IR control of the DVD and VCR, and for DC power. (See
Installing the DVCM 50, later in this guide, for information on how to connect
supported devices to this connector.)
6 MLC 104 communication port — This 3.5 mm, 3-pole captive screw
connector, located near the lower-left corner of the rear panel, is used
for connecting to the MLC 104 (special application). When the DVCM is
operating in standalone mode, this port is not used. (Refer to your DVCM
50 User’s Manual, chapter 4, for information on using the MLC 104 with the
DVCM 50.)
7 IR Learner/Transmitter LEDs — These sensors allow for IR control of
the DVCM and for IR learning. The two LEDs (one for transmitting, one
for receiving) send and receive IR signals, enabling the DVCM to learn
commands and clone confi gurations from another DVCM. (See Confi guring
using IR data transfer, later in this guide, for instructions on setting up for IR
data transfer.)
Front panel features
6
DVD & VCR CONTROL
PLAY NEXT/FWD PAUSE STOP
Tx
PREV/REW
ENTER
TITLE MENU
TV/VCR
DVD VCR
CONFIG
DVCM 50
4
TUNER
5 3
1
2
DVCM 50 front panel