Arcam FMJ AV9 - Manual (Page 36)

AV9
E-36
E
n
g
li
s
h
AV9
E-37
Technical specifications
NOTE: All specification values are typical unless otherwise stated.
Continual improvement policy
Arcam has a policy of continual improvement for its products. This means that designs and specifications
are subject to change without notice.
Audio
Line input sensitivity (set to Reference) 2V rms
Input impedance 10kΩ
Preamp output level (nominal) 2V rms
Output impedance 25Ω
Signal/noise ratio (unwtd 20Hz–20kHz) – analogue >100dB
Signal/noise ratio (unwtd 20Hz–20kHz) – digital (24-bit) >98dB
THD+N – analogue 0.0012%
THD+N – digital (24-bit) 0.0015%
Headphone maximum output level into 600Ω 5V p-p
Output impedance 5Ω
Video inputs and outputs
Input and output impedance 75Ω
Composite video level 1V
HF response to (–3dB) 12MHz
S-video level (Y/C) 1V / 0.28V
HF response to (–3dB) 12MHz
HQ (component) video
level (Y / Cr / Cb) 1V / 0.5V / 0.5V
level (R / G / B) 1V / 1V / 1V
HF response to (–3dB) 300MHz
Digital inputs
Coaxial connection (level/impedance) 0.5V/75Ω
Acceptable sampling frequencies, all inputs 44.1kHz, 48kHz,
(and 96kHz stereo only)
Digital output
Output level/impedance 0.5V/75Ω
Sampling frequency in ADC output mode 44.1kHz
Trigger outputs
Output D.C. voltage (excl. RGB status) 12V ±1V
Allowable load 30mA max (min 400Ω)
Remote inputs and output
Signal modulated 36kHz carrier
Coding Philips RC-5
General
Mains voltage range 85V to 265V
Power consumption 35VA
Power consumption (standby) 32VA
Dimensions Width x Depth x Height (including feet) 433mm x 360mm x 130mm
Weight (net) 9kg
Weight (packed) 14kg
Supplied accessories Mains lead,
CR80 remote control, 2 x AA
batteries
E&OE