Arcam FMJ AV9 User Manual
Page 24
AV9
E-24
E
n
g
li
s
h
AV9
E-25
Effects/FX
The
EFFECT
button (
FX
on the remote) cycles through the available
effect modes. The effects are only available when the AV9 is in stereo
mode.
For more information on the effects, see the section ‘DSP Effects
Modes’.
THX
This button cycles through the available THX modes. The available
THX modes change depending on what mode the AV9 is in and what
source material is being played.
For more information on THX, see the section ‘THX Modes’ on
page 30.
SUB
This button on the remote allows temporary trim of the Subwoofer level. Press
SUB
, then adjust using
the
D
and
E
buttons.
FAV
Use this button on the remote to clear any temporary adjustments and return to the current or
‘favourite’ preset settings.
MUTE
Use this button to mute the local zone. Press again (or use
VOL+/–
) to un-mute. The Mute LED will light
when zone 1 output is muted.
MODE
Use this button to cycle through the available surround modes.
INFO
Press this button on the remote once to display the local OSD report on source inputs and processing
mode. The display times out after about three seconds.
SYN
Delays may be introduced into the video signal by external video processing equipment which causes
a mismatch between the audio and video timing. You will notice this by speech sound being out of
synchronisation with the lip movements in the video.
To compensate for this you can adjust the lip sync audio delay. Press
SYN
and use the
D
and
E
navigation buttons to change the delay. Press
SYN
again to exit the lip sync function.
DISplay
This allows you to select the illumination level of the front panel display. Press
DISPLAY
on the front
panel or
DIS
on the remote to cycle through the settings Off/Dim/Bright.
TRIM
This allows temporary adjustment of the speaker levels. Press
TRM
to access the OSD ‘Speaker Trims’
menu, using the navigation buttons to adjust the levels required. Press again to exit the trim function.
As this is a temporary adjustment, the trim levels are reset to 0 when the unit is turned off or the
selected input is changed, but are retained if the unit is put in standby. These temporary trim levels are
independent of the ‘Level Settings’ page found in the Setup Menu.
Effect
Description
None
No effects active, stereo signal
Music
Extracted ambience and centre information
Party
All speakers on
Club
Small room
Hall
Medium reverberant room
Sport
Very reverberant with extracted ambience and dry
centre dialogue
Church
Long reverberant room