Xylem FM500 ULTRASONIC FLOW METERS - Manual (Page 39)

Page 39
displayed, as appropriate. If the user presses the YES soft button, the Working Set will
be reset, otherwise it will not. In either case, the Configuration Edit Menu re-appears.
If select Set Password from the Configuration Edit Menu, then a password can be
set or cleared for the Working Configuration Set. The prompt Enter five-digit password,
appears. Once five soft buttons have been pressed,
will be asked to repeat the
password to guard against entry errors. To escape from setting a password, it is sufficient
to deliberately enter two different sequences.
When this is completed, the Configuration Edit Menu returns. If have created a
new configuration and attempt to save the Working Set to a previously numbered
Configuration Set, then
will be prompted for the password of that Set, if one exists,
before it is overwritten. If opened an existing Set, then must have supplied the
password at that time and no further security measures are taken.
If select Save from the Configuration Edit Menu, the Working Set is saved to the
currently opened numbered Set. If created a new configuration and has not
previously saved it to a numbered Set, this selection is not available. You must use Save
As …, see below.
you
you
you
you
you you
you
you
If select Reset Working Set to Factory
Values from the Configuration Edit Menu,
then all configuration items that are
editable are set to values established by the
Factory Configuration. The prompt Are
you sure? (You will lose all information in
the Working Configuration Set) appears and
soft buttons are assigned to YES and NO. If
the Configuration Edit Menu was
reached by opening a saved configuration
set, the additional information (Configura-
tion Set # 3 will not be affected) will be
you
5.4.5
Reset Working
Set to Factory
Values Configuration Set #3
Reset Working Set to Factory Values
Are you Sure?
(You Will Lose All Information In the
Working Configuration Set)
(Configuration Set #3 will not be affected)
YES NO
5.4.6
Set Password
(for a single
configuration
set)
If select Save As … are offered the
five numbered Configuration Sets as choices
as shown at right. Y
should use
the and soft buttons, to select the
desired Set and press the ENTER soft
button to save the Working Set to that Set.
The Configuration Edit Menu returns.
The ESC soft button returns to the
Configuration Edit Menu without saving
the Working Set.
you you
ou
ENTER Ç ESC È
New Configuration Set
Save As...
Configuration Set #1
Configuration Set #2
Configuration Set #3
Configuration Set #4
Configuration Set #5
К
З
И
If select Save and Activate, what happens is as for Save above, but after the
Working Set is saved it is activated and the flowmeter exits the Setup Mode towards
Run Mode.
When attempt to save the Working Set to a numbered Set that is not the one
originally opened for editing, then if the destination Set has a password, will be
required to supply it before the Set is overwritten.
If the ESC soft button is pressed repeatedly until all Configuration Edit Menu
branches are closed and is then pressed one further time, the flowmeter takes the
“escape” path out of Setup Mode directly to Startup. Any changes made that have not
been saved are lost.
you
you
you
5.4.7
Saving
Changes
5.4.8
Escape Without
Saving
Ultrasonic Flowmeter