YSI IQ SensorNet DIQ/CR3 User Manual
Page 11

MIQ/CR3; DIQ/CR3
Installation
3 - 3
ba76032e01
01/2012
General installation
instructions
Observe the following points when attaching connecting wires to the
terminal strip
Shorten all wires to be used to the length required for the installation
Always fit all the ends of the wires with wire end sleeves before
connecting them to the terminal strip
Any wires that are not used and project into the enclosure must be
cut off as closely as possible to the cable gland.
Screw a small cable gland with sealing ring into each remaining free
opening and close it with a blind plug.
Warning
No free wires must be allowed to project into the enclosure.
Otherwise, there is a danger that areas safe to contact could come
into contact with dangerous voltages which could result in life
threatening electric shock when working with the IQ S
ENSOR
N
ET
.
Always cut off any wires that are not in use as closely as possible
to the cable gland.