Asus RS120-E3/PA2 - Manual (Page 30)

C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p 2 - 1 4 2 - 1 4 2 - 1 4 2 - 1 4 2 - 1 4
2.5.2 2.5.2 2.5.2 2.5.2 2.5.2 Reinstalling the riser card bracket Reinstalling the riser card bracket Reinstalling the riser card bracket Reinstalling the riser card bracket Reinstalling the riser card bracket
To reinstall the riser card bracket:
1. Take note of the holes on the riser card bay. The three pegs on the
riser card bracket should match these holes to ensure that the
bracket is properly in place.
2. Install the riser card bracket
with the card into the PCI
Express x8 and PCI-X slots on
the motherboard.
P e g s o n t h e r i s e r P e g s o n t h e r i s e r P e g s o n t h e r i s e r P e g s o n t h e r i s e r P e g s o n t h e r i s e r
c a r d b r a c k e t
c a r d b r a c k e t c a r d b r a c k e t c a r d b r a c k e t c a r d b r a c k e t
3. Press the riser card bracket until
the golden connectors
completely fit the slot and the
bracket aligns with the rear
panel.
4. Connect the cable(s) to the
card, if applicable.