Asus RS120-E5/PA2 - Manual (Page 42)

Chapter 2: Hardware setup 2-24
2.8.5. Optical.drive
To uninstall the optical drive:
2. Insert the optical drive emergency
eject pin to the emergency eject
pin hole until the drive tray ejects.
3. Pull out half of the drive tray to
remove the tray bezel.
1. Disconnect the power and signal
cables connected to the rear of
the optical drive.
4. Pull the center of the bezel
outward (A), then lift the sides (B)
to remove.
5. Replace the drive tray.
DO NOT apply too much force when removing the bezel. Too much force may
break the drive tray!