Asus P/I-P55TP4N - Manual (Page 50)

P/I-P55TP4N User's Manual 44
If you are auto-detecting a hard disk that supports the LBA mode, three
lines will appear in the parameter box. Choose the line that lists LBA for an
LBA drive. Do not select Large or Normal.
The auto-detection feature can only detect one set of parameters for a par-
ticular IDE hard drive. Some IDE drives can use more than one set. This is
not a problem if the drive is new and there is nothing on it. However, if the
drive is already formatted when you install it and different parameters than
those detected were used, you will need to enter them manually yourself.
If the parameters listed differ from the ones used when the drive was for-
matted, the drive will not be readable. If the auto-detected parameters do
not match the ones that should be used for your drive, do not accept them.
Press the key to reject the presented settings and enter the correct ones
manually from the Standard CMOS Setup screen.
Save and Exit Setup
Select this option to save into the CMOS memory all modifications you
specify during the current session. To save the configuration changes, high-
light the “Save & Exit Setup” option on the main screen and then press the
key.
Exit Without Saving
Select this option to exit the Setup utility without saving the modifications
you specify during the current session. To exit without saving, highlight the
“Exit Without Saving” option on the main screen and then press the ter> key.
IV. BIOS SOFTWARE
IV
. BIOS
(Load Setup Defaults)
IV
. BIOS
(Save & Exit)