Asus RX3041H - Manual (Page 70)

Chapter 9. Configuring Firewall/NAT Settings RX3041H User’s Manual
56
Field Description
IP Address Specify the appropriate network address
Subnet This option allows you to include all the computers that are connected in an
IP subnet. When this option is selected, the following fields become
available for entry:
Address Enter the appropriate IP address.
Mask Enter the corresponding subnet mask.
Range This option allows you to include a range of IP addresses for applying this
rule. The following fields become available for entry when this option is
selected:
Begin Enter the starting IP address of the range
End Enter the ending IP address of the range
IP Pool This option allows you to associate a pre-configured IP pool with this rule.
The available IP pool can be selected from the IP pool drop-down list.
Destination IP
This option allows you to set the destination network to which this rule should apply. Use the drop-
down list to select one of the following options:
Any This option allows you to apply this rule to all the computers in the
destination network such as those on the LAN for inbound ACL rules and
those on the Internet for outbound ACL rules.
IP Address, Subnet,
Range and IP Pool Select any of these options and enter details as described in the Source IP
section above.
Source Port
This option allows you to set the source port to which this rule should apply. Use the drop-down list to
select one of the following options:
Any Select this option if you want this rule to apply to all applications with an
arbitrary source port number.
Single This option allows you to apply this rule to an application with a specific
source port number.
Port Number Enter the source port number
Range Select this option if you want this rule to apply to applications with this port
range. The following fields become available for entry when this option is
selected.
Begin Enter the starting port number of the range
End Enter the ending port number of the range
Destination Port
This option allows you to set the destination port to which this rule should apply. Use the drop-down
list to select one of the following options:
Any Select this option if you want this rule to apply to all applications with an
arbitrary destination port number.
Single, Range Select any of these and enter details as described in the Source Port
section above.