Asus RX3041H - Manual (Page 57)

RX3041H User’s Manual Chapter 7. Configuring Routes
43
8. Repeat steps 3 to 7 if you want to configure another interface to support routing information
exchange.
9. Click to save the RIP configuration.
7.3 Static Routing
7.3.1 Static Route Configuration Parameters
The following table defines the available configuration parameters for static routing configuration.
Table 7.2. Static Route Configuration Parameters
Field Description
Destination IP
Address Specifies the IP address of the destination computer or an entire destination
network. It can also be specified as all zeros to indicate that this route should
be used for all destinations for which no other route is defined (this is the
route that creates the default gateway). Note that destination IP must be a
network ID. The default route uses a destination IP of 0.0.0.0. Refer to
Appendix A for an explanation of network ID.
Destination Netmask Indicates which parts of the destination address refer to the network and
which parts refer to a computer on the network. Refer to Appendix A, for an
explanation of network masks. The default route uses a netmask of 0.0.0.0.
Gateway IP Address Gateway IP address
7.3.2 Adding a Static Route
Follow these instructions to add a static route to the routing table.
1. Open the routing configuration page by clicking on the Routing menu.
2. Enter static routes information such as destination IP address, destination
netmask and gateway IP address in the corresponding fields.
For a description of these fields, refer to Table 7.2. Static Route Configuration Parameters.
To create a route that defines the default gateway for your LAN, enter 0.0.0.0 in both the Destination
IP Address and Destination Netmask fields.
Figure 7.2. Static Route Configuration
3. Click to add a new route.
7.3.3 Deleting a Static Route
Follow these instructions to delete a static route from the routing table.