GE Industrial Solutions EntelliGuard G Fixed Secondary Disconnect - Manual (Page 2)

7. Assemble back the 3 nuts as shown in fig 4.
Figure 1. (A) Front Cover (B) Screw Removal (C) Handle
Rotation
Figure 4. Nuts assembly
3. Remove all the coils (refer to DEH41411.)
8. Complete the SD Wiring.
9. Assemble back all the coil accessories (refer to
DEH41411).
4. Remove all the equipment wiring and accessories
wiring from the secondary disconnect.
10. To reinstall the cover, rotate the charging
handle down and slide the front cover over the
handle to assemble the front cover to housing as
shown in Fig. 5
5. Remove the 3 nuts as shown in fig 2.
Figure 2. Nut Removal
6. Replace the one block assembly with the 2-block
assembly as shown in fig 3.
Figure 5.
11. Ensure the fascia is aligned properly with the
trip unit and the pad lock features of the breaker.
12. Fasten the 6 mounting screws of fascia with
the housing using a pozidrive screwdriver. Apply
torque of 6 Nm (4.42 ft-lbs).
Figure 3. SD assembly
2