Slide number 4 – Pro Series 30092 FIFTH WHEEL SLIDERS User Manual

Page 4

30092IN– 10-13-09 D

PCN12675

Printed in XXXXXX

Reference label
facing driver side.

3. Before setting the Pro Slider into the bed of the

pickup, attach handle shaft to handle elbow (see
figure 1 on first page). Insert handle assembly
through left hand slide assembly (driver’s side of
towing vehicle) and then through the right hand side
slide assembly (see figure 8).

4. Set the Pro Slider into base rails and pin in

position with the Pro Series Slider in the
middle of the tubes (see figure 9).

figure 9

figure 8

2. Before installing the Pro Slider, leaf spring must be

greased as shown using white lithium grease or
equivalent (see figure 7). For best results, use
aerosol white lithium grease with a spray nozzle
extension. Make sure entire underside of spring is
coated! Repeat this application monthly during use.

1. These instructions should be used to mount the Pro Slider. Care and attention to detail will ensure a quick, safe and
quality installation. Check parts against figure 1 to become familiar with kit.

INSTALLATION

WARNING:

Pull pin spring clips must

be on the outside of base rail

as shown. Spring clips

installed on the inside of

base rail will not allow Pro –

Series Slider to slide far

enough to lock. Pro Sliders

that are not properly locked

can suddenly move and

cause serious injury or

death.

Slide Tube

Pro Slider Upright

Aerosol white lithium
grease spray with nozzle
extension

Leaf spring

figure 7

See figure 10 for
installed clip locations.