Pro Series 51196 51 Receiver - Manual

Installation Instructions
Toyota Sienna
Part Numbers:
51196
Do Not Exceed Lower of Towing Vehicle
Fascia
Hitch Shown In Proper Position
Equipment Required:
W h 10 19 6” Ratchet
Fastener Kit: 51196F
Manufacturer’s Rating or
Wiring Access Location: SUV1, 2
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing 5000 (2270 Kg) 500 (227 Kg)
Weight Carrying
Ball Mount
3500 (1589 Kg) 350 (159 Kg)
Wrenches: 10mm, 19mm, 6” Ratchet
Extension, Large screwdriver
Drill Bits: None
Existing Weldnut
3 Places
(Both Sides)
Frame Rail
Area to be trimmed
To be reinstalled
Note:
Fasteners Typical
Both Sides
Area to be trimmed
To be reinstalled
Figure 2
Sport Model
1
Appearance panel
For vehicles with appearance panel: Remove appearance panel which covers the trunk pan. This panel will need to be trimmed or not reinstalled
1 Qty. (6) Flat Washer, 1/2” 3 Qty. (6) Hex Bolt, M12 x 1.25 x 40mm
2 Qty. (6) Lock Washer, 1/2”
Area to be trimmed
Figure 1
1
2
3
on vehicle. Ask vehicle owner their choice before starting installation. See Figure 2
1. Remove plastic plugs, from existing holes (if present).
2. Raise hitch into position over the exhaust pipes aligning the slots in the hitch with the weldnuts in the bottom of the frame rails. NOTE:
Lowering exhaust may ease installation. Spraying a lubricant on the metal hanger rod and the rubber isolator helps removal.
3. Install fasteners as shown above.
4. Torque all fasteners to specifications shown below.
5. Raise exhaust back into position, if lowered prior to hitch installation.
6. Reinstall trimmed cover panel removed. Or return untrimmed panel to vehicle owner.
z 2010 Cequent Performance Products Sheet 1 of 3 51196N 6-1-10 Rev. A
Tighten all M12 CL10.9 fasteners with torque wrench to 75 Lb.-Ft (102 N-m).
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.