Pro Series 51149 51 Receiver - Manual

Bumper
Structure
Fascia
Pins
FIGURE 1
Installation Instructions
Jeep Grand Cherokee
Jeep Commander
Part Numbers:
51149
For vehicles with OEM Tow Hook: Tow hook must be permanently removed for hitch
installation. Installation time will increase from 20 Min. to 90 Min.
1. Lower the spare tire.
2. Remove two plastic pins that hold bumper fascia onto bumper structure as shown in Figure 1. (If OEM tow hook is present: Remove fascia,
plastic bumper support and tow hook)
3. Gently pull fascia rearward about one inch and raise the hitch into position as shown in Figure 1.
4. If there is excessive gap between the vertical surfaces of the hitch and the bumper structures, flat washers should be used as shims. They can
be held in place using cellophane tape. See Figure 2.
5. Secure hitch with fasteners. Fascia may contact the back of the hitch. (Reinstall fascia and plastic bumper support if removed in Step 2.)
6. Replace plastic pins in bumper fascia.
7. Raise the spare tire into storage position.
Tighten all 1/2-13 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Rev. A 8-11-09 51149N Sheet 1 of 3 z 2009 Cequent Performance Products
Conical Washer, 1/2” Qty. (4) 2
Flat Washer, 1/2” Qty. (8) 3 Hex Bolt, 1/2-13 x 4” Qty. (4) 1
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Equipment Required:
Wrenches: 3/4”
Fastener Kit: 51149F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
500 (227 Kg) 5000 (2270 Kg)
Weight Carrying
Ball Mount
750 (341 Kg) 7500 (3405 Kg) Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Wiring Access Location: SUV1, SUV2
FIGURE 2
Hitch Shown In Proper Position
Bumper
Structure
Bumper
Fascia