Pro Series 51087 51 Receiver - Manual

Installation Instructions
Toyota FJ Cruiser
Part Numbers:
51087
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 19mm, ¾, Torque
1. If present, remove the tie down bracket from vehicle frame rail and discard bolts. Tie down bracket will be re-attached with new hardware.
2. Feed the carriage bolt and block thru slots in side of frame rails using the pull wire.
3. Raise the hitch into position; lifting the bumper mounting bracket over the fascia (where needed). Secure with M12 bolts and conical washers into
the existing weld nuts, being careful not to push the bolts into the frame.
4. Hand tighten all bolts.
5. Tighten all 1/2-13 GR5 fastener with torque wrench to 75 Lb.-Ft. Tighten all M12 CL10.9 fasteners with torque wrench to 75 Lb.-Ft.
Rev. A 10-9-07 51087N Sheet 1 of 3 z 2007 Cequent Towing Products
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 51087F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
500 5000
Weight Carrying
Ball Mount
600 6000 Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Form: F205 Rev A 5-6-05
Fascia
9 Hex Nut 1/2-13 Qty. (2) 4
7 Carriage Bolt 1/2-13 Qty. (2) 3
Pull Wire Qty. (2) 6 Conical Washer Qty. (6) 2
Block 1” X 1.5” Qty. (2) 5 Hex Bolt M12 Qty. (4) 1
Wiring Access Location:
Block 1” X 1.5”
Pull Wire
Hex Nut 1/2-13
Carriage Bolt 1/2-13
Conical Washer
Hex Bolt M12
Tie Down Bracket