OSRAM HALOTRONIC-PROFESSIONAL HTL User Manual

Page 20

5.4 Installation

correct wiring

incorrect wiring

Fig. 11

5.4.1 Ease of installation

L models:

• Blanking caps on the primary and secondary sides can be easily

levered off with a screwdriver, saving you considerable time and
effort.

• Two pairs of terminals on the primary side for mains looping from

unit to unit; a maximum current of 6 A may be looped through.

• One and the same screwdriver can be used to lever off the blan-

king caps, connect the wires and adjust the strain relief.

• Strain relief possible on the primary side for e.g. two NYM 3x.5

cables, three pairs of terminals on the secondary side for the

parallel connection of three luminaires.

• Sufficient cable space in front of the screw terminals.

LF models:

• Extremely low-profile design

• Two pairs of terminals on the primary side for mains looping

through

• Strain relief possible on the primary side for two NYM 3x.5 mm

cables

• Two pairs of terminals on the secondary side for the parallel con-

nection of two luminaires

HT…L

Fig. 2