Mustang Motorcycle Seats Driver Backrest Kit, Regal - Harley-Davidson FL Touring, Chrome Studs - Manual

Installation Instructions:
Frame-0ounted 'river %ackrest .it
FL 7ouring 0odels, 2009-201
The Mustang driver backrest kit can be used with the stock one-piece seats and
with the Mustang one-piece touring seats that have the center opening to accept
the backrest. This unit cannot be used with any solo seat or two-piece seat.
Step 1
Remove the seat from the motorcycle.
Step 2
Locate the two 1/4-20 studs in the fender
and remove the nuts from them. These nuts will
be used to attach the rear of the driver backrest
receiver base.
Step 3
Locate and remove the two rear battery
cover bolts. These two bolts will secure the front
portion of the driver backrest receiver base.
Step 4
Place the receiver base onto the motorcy-
cle over the two fender studs and aligned with the
two threaded holes at the rear of the battery
cover. Secure with two bolts and two nuts re-
moved earlier. Tighten front bracket bolt.
Step 5
Re-install the seat and secure with the
rear fender screw.
Step 6
Insert the driver backrest post through the
seat opening and into the receiver base.
Step 7
Adjust height and tilt angle of backrest
pad for optimum driver’s support and comfort.