Mustang Motorcycle Seats Cyclone Hardware Kit 2006-2013 FLSTB Cross Bones (stock spring system) User Manual
Page 2
Mounting Suggestions Harley‐Davidson® Wide Tire Softail Crossbones Only 2008‐201ϯ Cyclone Solo Seat with Spring Mount cont. from pg 1
Installation of Mustang Cyclone Solo seat with spring mount:
1. Turn Mustang Cyclone solo seat over to attach mounting hardware to baseplate.
Step 2
Step 2
Step 3
Step 4
Step 5
Step 6
These
steps are
guidelines
to
help
you install
your
new
Mustang
product.
If
you need further assistance please call us at 860‐582‐9633, Monday through
Friday 9:00 ‐ 5:30 Eastern or send an email to
website at
www.mustangseats.com
For care and maintenance of our seats, please go to our website under
“Support”
.
Ref: Cyclone Solo Seat part #’s 76615, 76616, 76617, 76618, 76621 Frame Mounting Plate 76626
Enjoy your new
Mustang seat
2. Install supplied pivot mount adapter bracket
#B30127 to nose of the Cyclone solo seat base‐
plate using two ¼‐20 x 5/8” long Phillips flat
head screws. Tighten.
3. Place the stock HD front pivot mount (HD #51482‐08) which was removed from
the stock seat, onto the 5/16” stud on the pivot mount adapter bracket.
4. Attach pivot mount using 5/16 flat washer and 5/16‐18 flange nut. Tighten.
5. Attach spring and bracket assembly from stock seat onto rear of Mustang
Cyclone solo seat using the two ¼‐20 x ¾” long Phillips truss head screws.
Tighten.
6. Align the pivot mount with the frame mount at the base of the gas tank
and install the stock pivot screw. Tighten. Springs are a friction fit over
rear studs.