Mustang Motorcycle Seats One-Piece Deluxe DayTripper Seat - Harley-Davidson FLHT User Manual
Page 2
Mounting of Mustang Seat
1. Engage the nose bracket into the frame.
2. A firm downward punch or chop to the nose of the seat will push the seat
closer to the chrome dash.*
3. The seat is spring loaded so the rear tab will be above the fender
approximately 1” to 1 1/2”.
4. Secure the stock rear fender screw.
Enjoy the Comfort of your new Mustang Seat!
* If there is a gap between the nose of the driver seat and the dash, be sure seat is as far forward as
possible and adjust the chrome dash. Dash is adjusted by loosening the 1/2" hex nut and phillips screw
on dash. Slide dash back and retighten. On 2004 and newer models nose bracket on seat can be
opened up approximately 1/4" for best fit.
† Road King rack mounted backrests are adjustable. All Mustang Road King seats are most
comfortable with the passenger backrest pads in the rear-most position. Fully loosen the four nuts
under the outer rack channels and tap the backrest rearward to the end of the slots. Retighten the nuts.
† All wiring harnesses must be positioned on the inside of the frame rails. If necessary cut the factory
tie wraps and roll harness inside the rail and retie with supplied black tie wraps.
These steps are guidelines to help you install your new Mustang product. If you need further assistance,
please call us at 800-243-1392, Monday through Friday 9:00 - 5:30 Eastern, or send an email to
[email protected], or visit our website at www.mustangseats.com.
For care and maintenance of our seats, please go to
Ref part #75601, 76025, 75646, 76614, 79603, 79538, 79539, 79546, 79606, 79556, 79558, 79579,
79586, 79608, 79609, 76036, 76037, 76038, 76039, 76033, 76034, 76030, 76031, 76032, 79650, 79651, 79652, 79653,
79654, 79655