Mustang Motorcycle Seats Driver Backrest Kit, Smooth with Chrome Studs - Harley-Davidson FLHT - Manual

Installation Instructions:
Frame-mounted driver backrest kit
For FL touring models, 1997-2008
The Mustang driver backrest kit can be used with the stock one-piece seats and
with the Mustang one-piece touring seats that have the center opening to accept
the backrest. This unit cannot be used with any solo seat or two-piece seat.
Step 1 Remove the seat from the motorcycle.
Step 2 For model years 1999-2008, locate the
two 1/4-20 studs in the fender and remove the
nuts from them. These nuts will be used to attach
the driver backrest receiver base.
For model years 1997-1998, there are two 5/16
bolts that need to be removed and used later to
attach the receiver base.
Step 3 Locate the pre-drilled hole in the frame
member located just above and behind the bat-
tery. Slip the supplied flat nut over this hole and
align it to accept the supplied 1/4-20 bolt.
Step 4 Place the receiver base onto the motorcy-
cle by aligning the two studs or screw holes and
the single mounting hole; attach and secure using
the stock nuts on the two studs or the two 5/16
bolts at the rear and the supplied bolt at the front
attachment point.
Step 5 Re-install the seat and secure with the
rear fender screw.
Step 6 Insert the driver backrest post through the
seat opening and into the receiver base.
Step 7 Adjust height and tilt angle of backrest
pad for optimum driver’s support and comfort.
These instructions apply to part numbers:
79062, 79063, 79065, 79067, 79068, 79070